Publicité
Les langues disponibles
Les langues disponibles
2. As for the way to check whether you need to add lubricant
again. Just grab the running belt and touch the middle of the
running belt back with your hands as much as possible. You
don't need to add lubricant if you have silicone on your hand
(a little moist). You have to add lubricant if the pad is dry
and there is no silicone on your hand.
★ The step of lubricating on the running board (as shown in the
picture);
★ Stop the running belt and fold the machine;
★ Lift up the running belt on the bottom, extend the oil into the
middle of the running belt as much as possible, spray
methyl-silicone oil on the inner side of the running belt, and coat
both sides of the running belt with methyl-silicone oil;
★ You can make use of the treadmill speed of 0.6mph to evenly
lubricate and step on the running belt from left to right. After a few
minutes, the methyl silicone oil can be completely absorbed by the
running belt.
3. Adjust tightness of running belt
All treadmills shall be adjusted for tightness before delivery and
after installation. However, the running belt may be loosened after a
period of use. For example,the treadmill has problems with stopping
and slipping during exercise. Adjust bolts of running belt with the
left and right synchronous as per clockwise direction to half a circle
as the unit when this phenomenon occurs. The feet will slip if the
running belt is too loose. But it is not good to be too tight. It is easy
to increase the load of the motor and damage the motor, running
belt and roller etc.
14
4. Running belt deviation adjustment
All treadmills need to be adjusted the running belt before delivery
and after installation. But the running belt may be deviated after a
period of use which may be caused by the following reasons.
① The main body is not placed smoothly.
② The feet of users are not in the center of the running belt.
③ The feet of users are uneven force.
The deviation caused by man can be returned to normal after
a few minutes of no-load rotation. For deviation of
non-recover automatically, it should be adjusted with 6mm
wrench at a half circle as the unit.
Please adjust left bolt with
clockwise or right bolt with
counterclockwise if running
belt is left deviation.
Tips: It is mainly maintained by the user according to the
manual. Running belt deviation will seriously damage the
running belt. The mistake must be found in time and
corrected.
Please adjust right bolt with
clockwise or left bolt with
counterclockwise if running
belt is right deviation.
15
Publicité
