tormek MB-102 Multi Base Instruction page 5

Setting the Sharpening Angle When Sharpening on the Side of the Grinding Wheel
When setting the sharpening angle with the updated WM-200 AngleMaster, use the top
angle scale, marked with MB-100/MB-102 (image 1). When setting the sharpening angle
with the previous WM-200, add 18° to your preferred angle (image 2). For example, if you
are going the sharpen a chisel to a 25° angle, add 18° on the AngleMaster, i.e. 43°. Always
set the wheel diameter compensator on WM-200 to 250 mm when sharpening on the side
of the Diamond Grinding Wheel with the MB-102 Multi Base.
1. Setting with the updated WM-200
Use the top angle scale, marked with MB-100/MB-102.
2. Setting with the previous version of WM-200
Add 18° to your preferred angle.
EN
5