Monster Power Signature HTPS 7000 MKII Mode D'emploi page 32

Symptom
"Timed On"
indicator on front
panel is Off.
Video picture
has rolling bars
or ghosting.
The PowerSource
is emitting a loud
buzzing alarm.
24
TROUBLESHOOTING
Possible Cause
You are using the Remote Turn-On feature
(Same as Switched) and haven't plugged
the plug into the component you wish to use
to activate the Remote Turn-On.
The component remote control you are using
to power the Remote turn-on has a dead battery.
The component you wish to use to activate the
Remote Turn-On isn't plugged into a properly
grounded 120 volt (nominal) outlet.
The incoming video signal is
not properly grounded.
The PowerSource protection circuitry has
sacrificed itself to protect connected equipment
from a catastrophic surge.
Remedy
• Plug the plug into component you
wish to use to activate the Remote
Turn-On.
• Replace the battery powering
the component remote control.
• Plug the component into a properly
grounded 120 volt (nominal) outlet.
• Contact your cable or satellite
provider to correct your installation.
• The PowerSource must be replaced.
See the Warranty Information section
for important details.