Monster Power Signature HTPS 7000 MKII Mode D'emploi page 29

Symptom
The PowerSource is
not receiving power.
TROUBLESHOOTING
Possible Cause Remedy
The PowerSource • Turn the PowerSource switch on.
is not turned On.
• Make sure the PowerSource's AC power plug
• In some households, a wall switch may need
Too many devices are • Press the PowerSource Thermal Circuit Breaker
connected, causing an
overload, tripping the
Thermal Circuit Breaker.
• If the Circuit Breaker continues to trip,
is plugged into a properly grounded 120 volts
(nominal) wall outlet.
to be thrown to make the wall plug active. Try
turning on the light switches located near the
wall unit.
button in to reset. Please allow
10 minutes before attempting to reset.
If you reset too soon, the breaker will
prematurely sense power overload and
not allow unit to operate.
try moving one or more components
to another PowerSource. You may be drawing
too much current through one PowerSource.
21