Panasonic EY37A2B Instructions D'installation page 11

III.
ASSEMBLY
Battery Installation
NOTE:
If the batteries are removed from both the
main battery pack compartment and back
up battery compartment, initialization will
be performed about three minutes later.
Installing back up batteries [Fig. 1]
1. Pull out the battery compartment locker to
release battery compartment. There are
main battery pack compartment and back up
battery compartment.
2. Remove back up battery compartment cover
and insert 2 fresh UM-3 (AA sizes). Make
sure the batteries are with correct polarity as
shown inside the compartment. Replace the
battery cover.
NOTE:
• The radio can be used without connecting
the backup battery.
• Keeping back up batteries inside the
compartment prevent stored data in
preset memories from being lost.
CAUTION:
• Do not use any batteries other than those
specified (UM-3).
• Remove batteries if product is not to be
used for a long time.
• Do not mix new batteries with old ones or
use different types of batteries together.
Improper use of batteries may result in
battery leakage, heat generation, fire or
explosion.
If any fluid is leaking from the batteries,
pay careful attention to the following
safety points.
• Never touch battery fluid with your bare
hands. Doing so could result in a skin
inflammation or an injury.
• Blindness could result if the fluid gets in
your eyes.
• Completely wipe up any spilled battery
fluid.
Attaching/Removing main battery pack
[Fig. 2]
1. After back up batteries are inserted, insert
the main battery pack to the main unit.
Always insert it all the way until it locks
in place with a little click. The suitable
battery packs for this radio listed in the
Specifications.
2. To remove the battery pack, pull the battery
off the compartment.
3. Return the battery compartment locker to the
original position.
Low battery indicator
1. Reduced power, distortion and a "stuttering
sound" or low battery sign (
appears on the display are all the signs that
the main battery pack needs to replace.
NOTE: The battery pack can't be charged
via the supplied AC power adaptor.
2. When the main battery is removed and the
low battery sign (
shown on the display, this indicates that it is
time to replace the back up batteries.
Using the soft bended antenna [Fig. 3]
Straight up the soft bended antenna.
CAUTION:
The soft bended antenna works in one
direction only.
Forcibly bending it can cause it to break or
result in an injury.
Using Supplied AC power adaptor
CAUTION:
• Disconnect the AC power adaptor's
jack from the main unit when using the
battery pack.
The power will not turn on if the AC power
adaptor's jack is connected to the main
unit, even if the battery pack is mounted.
• The mains plug power adaptor is used
as the disconnect device.
When using AC power adaptor, the
socket-outlet shall be installed near the
equipment and shall be easily accessible.
Remove the rubber cover and insert the
adaptor plug into the DC socket on the right
side of the radio. Plug the adaptor into a
standard mains socket outlet. Whenever the
adaptor is connected, the battery pack is
automatically disconnected. The AC adaptor
should be disconnected from the main
supply when not in use.
- 11 -
) that
) flashes and an "E" is
EN