Publicité
Les langues disponibles
Les langues disponibles
ETF MT 100
Maintenance
There are certain general maintenance procedures you should perform to keep
your MicroTorque system clean and operating at its efficiency.
The system is a sophisticated instrument with many sensitive components.
A built-in service reminder can be configured in Tools Talk MT. When it is
time to perform service on the tool, a reminder is shown on the controller dis-
play.
Preventive Maintenance:
• The system should never be exposed to harsh environment with rapid tem-
perature changes or excessive dust.
• Never expose the system to excessive vibration or high humidity.
• Prevent overheating by use only in the permitted temperature range. Do not
cover tool or controller or power supply.
• Cleaning of the tool and controller should be done regularly, but not with
aggressive cleanser.
• Check wear of the bit regularly.
• Replace worn cables immediately.
Tools which have been opened by anyone else than Atlas Copco Industrial
Technique AB, will not be serviced.
Calibration and preventive maintenance is recommended at regular intervals
once per year or after maximum 1.000.000 tightenings depending on which oc-
curs sooner.
More frequent overhaul may be needed if the machine is used in heavy-duty op-
erations.
If the machine is not working properly, it should immediately be taken away for
inspection.
EN
© Atlas Copco Industrial Technique AB - 9836 601900 00
Product Instructions
5
Publicité
