Norwood LumberPro HD36V2 Instructions Originales page 22

WARNING: the following is to be done by a certified electrician.
EN–18
MILL-ELEC-S1-INST (2022-04-04).indd 18 MILL-ELEC-S1-INST (2022-04-04).indd 18
Remove the motor cable clamp and
terminal box cover using a screw driver.
Insert the cable from the control panel
inside the clamp as illustrated here.
Make sure the terminals are as shown
here (not bar crossing the terminals).
Remove the nuts of each terminal and
connect the proper cable to the proper
terminal (follow labels attached to
cables).
Secure each cable with the nuts
previously removed.
Connect the ground wire.
2022-04-04 6:18:57 PM 2022-04-04 6:18:57 PM