Norwood LumberPro HD36V2 Instructions Originales page 13

Assembly
Before assembly, inspect parts to detect any apparent
damage. If there is damaged or missing parts, inform
Norwood Sawmills immediately.
Note: these instructions are used to assemble the electric
package for your sawmill. Some parts and pictures might not
be identical to your sawmill but are similar.
Please use these instructions in conjunction with your
sawmill manual.
For LumberPro HD36v2 Owners — Before You Start!
One part called "Rear leg assembly (HD36) – Spacer"
#LM34-C0220-SPC of the 7.5 kW/400 v electric package
has to be installed in two locations during the assembly
of your LumberPro HD36v2 carriage. This part must be
installed before the step shown below, found under "Carriage
Assembly" in the LumberPro HD36v2 manual.
MILL-ELEC-S1-INST (2022-04-04).indd 9 MILL-ELEC-S1-INST (2022-04-04).indd 9
Installation Requirements
Electrical system providing a residual
current device with a maximum
residual current of 0.03A should be
provided. Installation of over-voltage
protection is needed.
»
Steady state voltage: 0.9-1.1 of nominal
voltage (400 V~).
»
Frequency: 0.99-1.01 of nominal frequency
continuously;
»
0.98-1.02 short time.
»
HVF: ≤0.02
Install the left (186) and right (187) rear
leg assemblies, LOOSELY. DO NOT
TIGHTEN ANY BOLTS YET.
Use 3/8 x 3/4" flange bolts (33A). Finger
tight only.
See Trailer Assembly section
if assembling a sawmill with
trailer package.
The part #LM34-C0220-SPC has to be
installed as per the picture here using
the 3/8" x 1.0" bolts and 3/8" nylon lock
nut.
Then continue the assembly of your
Norwood sawmill as per the owners
manual.
EN–9
2022-04-04 6:18:46 PM 2022-04-04 6:18:46 PM