Marmitek SS13 Guide Utilisateur page 8

the power line. Only one Transceiver should be installed for all remotes and
sensors set to the same House Code.
Am I able to increase the range of my remotes by using more
Transceivers?
Yes, you can use more than one TM13 Transceiver in your home when the
range of your remotes is not sufficient. The TM13 is using so called collision
detection to prevent signals to be disturbed when more than one TM13 is
transmitting. TM13's will wait for a quite power line before transmitting
their data. To prevent your Marmitek X-10 System to become slow or to
prevent dimming from becoming less smooth, make sure that the TM13
units are placed as far away from each other as possible.
The other modules do not respond to signals of the SS13. What can
be the problem?
• Check if the SS13 has been set-up correctly. The easiest way to do this
is to give again the correct HouseCode to the top button.
• Has the battery been placed correctly?
• The SS13 uses a Transceiver module (TM13, IRRF7243 or one of the
Marmitek X-10 alarm stations). Check if it works properly, for instance
to use another remote control.
• Maybe the range of the SS13 is not sufficient for your purpose; if so,
when using a TM13, place an extra TM13 in the neighbourhood of
your SS13.
Do you still have questions? Please check out www.marmitek.com
for more information.
8 © MARMITEK