Publicité
Les langues disponibles
Les langues disponibles
If you're going on vacation
If your appliance is not to be used for several months, remove all food, turn off and unplug the appliance from
the outlet. Clean and dry the inside and outside of the appliance thoroughly. Also leave the door open, blocking
it if necessary, to prevent condensation, odors, mold.
Moving the unit
▪
Location
Do not place your refrigerator near a heat source, for example. Stove, boiler or radiator. Also, avoid direct
sunlight.
▪
Leveling
Make sure the appliance is level. Use the adjustable feet at the front. If the appliance is not level, the doors
and magnetic sealing alignments will be affected and may cause malfunctions.
▪
Refrigerator upgrade
Make sure the refrigerator is level. Use the rotatable adjustable feet at the front. If the refrigerator is not level,
the doors and magnetic sealing alignments will be affected and may cause malfunctions.
▪
Do not turn on the refrigerator for 4 hours
After any movement, it must not be connected for 4 hours. This delay allows the coolant to be adjusted.
▪
Installation
Let your device breathe. Heat is released from the walls so it is important to leave a circulation of air around
your device.
Energy saving tips
▪
The refrigerator should be located in the coolest area of the room, away from heat producing
appliances or heating ducts, and out of the direct sunlight.
▪
Let hot foods cool to room temperature before placing in the refrigerator. Overloading the refrigerator
forces the compressor to run longer. Foods that freeze too slowly may lose quality, or spoil.
▪
Be sure to wrap foods properly, and wipe containers dry before placing them in the refrigerator. This
cuts down on frost build-up inside the refrigerator.
▪
Refrigerator storage bin should not be lined with aluminum foil, wax paper, or paper toweling. Liners
interfere with cold air circulation, making the refrigerator less efficient.
▪
Organize and label food to reduce door openings and extended searches. Remove as many items
as needed at one time, and close the door as soon as possible.
Turn off your appliance
▪
If the unit is not likely to operate for a long period of time:
▪
Remove all food from your appliance from the appliance.
▪
Switch off the appliance by setting the thermostat to position "OFF".
▪
Unplug the appliance.
▪
Clean it thoroughly.
▪
Keep the door open to prevent odors from rising.
Changing the light bulb
This appliance consists of light-emitting diodes (LEDs). This type of diode
cannot be changed by the consumer. The lifetime of these LEDs is normally
sufficient for no change to be made. If however, and despite all the care taken
during the manufacture of your appliance, the LEDs were defective, please
contact your after-sales service for any intervention.
34
Publicité
