Polar Refrigeration CM359 Mode D'emploi page 6

Defrosting
1) The unit defrosts automatically
Reversing the door swing of your appliance
1) Open the glass door 4 and remove the two lock screws 2 that hold the door shaft assembly
to the door. Make sure that you hold the door firmly once the screws have been removed
(Fig. 1)
2) Pull down to remove the door and lay it on a padded surface to prevent scratching
3) Remove the two screws from the bottom of the door on the left hand side and install them
on the right hand side of bottom of the door (Fig 3.)
4) Remove the right lower door hinge 1. Take the left lower door hinge 6 from the plastic bag
and install it in designated position on the left hand side. Then install the door shaft
assembly (Fig 2)
5) Remove the door axle 5 from the right upper hinge, install and tighten it in the upper left
hinge (Fig 4.)
6) Position the door in the designated position and install the two lock screws 2 to connect the
door shaft assembly 3 to the glass door. Tighten them before the door is levelled (Fig 5).
7) Remove the handle from the left hand side of the door and install it on the right