Polar Refrigeration CM359 Mode D'emploi page 3

Product Description
CM359 Polar Wine Chiller – 54 Bottle Capacity
Pack Contents
Polar Wine Chiller
Installation
WARNING: When positioning the appliance, ensure the supply cord is not
trapped or damaged.
WARNING: Do not locate multiple portable socket-outlets or portable power
supplies at the rear of the appliance.
Before using your wine chiller
1) Remove all the exterior and interior packaging
2) Before connecting the chiller to the power supply, let the chiller stand upright for
approximately 12 hours
3) Clean the interior with lukewarm water, using a soft cloth
4) The door can be opened from either the left or right side. When delivered, the door can be
opened from the left. Should you want to open it from the right, follow the instructions for
"reversing the door swing of your appliance"
Installing your wine chiller
1) The product is designed to be built-in, recessed, or free standing
2) Place the chiller on a floor that is able to support it once fully loaded. To level the chiller,
adjust the front levelling leg at the bottom of the chiller
3) Don't place the chiller in direct sunlight or near other heat sources.
4) Avoid placing the chiller in damp areas
5) Plug the chiller into the socket.
6) Ensure that the air vent at the front of the chiller is never blocked or covered
Installing the handle
1) Remove the door gasket on the side you want to install the handle – there are two
designated holes for the handle installation
2) Install the handle tightly with two screws, lock washers and flat washers provided
3) Replace the door gasket
Keys Instruction Manual