Publicité
Les langues disponibles
Les langues disponibles
REPAIR KIT
WARNING
Wear latex gloves. Avoid contact with skin & eyes. Avoid breathing cement vapors.
01
Prepare the following items:
/ Latex gloves - Not included
/ Rubbing Alcohol - Not included
/ Clean cloth - Not included
/ Cement applicator - Not included
/ Colle à PVC pour application en extérieur – Not included
/
(Exemple: GEAR AID Aquaseal FD)
/ Repair kit included items:
• PVC patchs, grey and blue
• Valve clamping tool (handle)
• Replacement screws
02
Deflate paddle board.
03
If the valve needs to be retightened or replaced, use the valve handle
provided with the repair kit.
04
Lightly sand the surface of the board, with very fine paper,
where the PVC patch will be glued.
05
Clean the surface around the leak as well as the matte side of the
PVC/Polyester patch with rubbing alcohol.
06
Follow the glue-specific application and drying time instructions
you have on hand.Allow 8 hours before inflating paddle board.
07
Wait a minimum of 24 hours and check that the piece of PVC is well
bonded over its entire surface before inflating your board.
8
Publicité
