STORAGE
/ Keep your board in a well-ventilated, shaded area when not in use.
/ Direct sunlight can damage a board left exposed for a period of time.
/ Heat may cause the air inside to expand beyond the pressure limits.
/ Keep your board in an area with good air flow and circulation.
/ Leaving your board in a vehicle during the day elevates the risk for heat
related damages.
/ Improper inflation or deflation may result in damaging your SUP
/ The optimal inflation pressure is 15 psi.
/ Do not store your board in a board bag for extended periods of time.
Board bags are intended for transportation, not for full time storage.
Prolonged storage of a wet board in a wet bag will lead to the possibility
of mould and osmotic blisters. Board bags also collect heat and can
potentially overheat your board.
INFLATION
The pump can be used in double-action mode during the inflation phase.
QUICK INFLATION MODE:
Turn valve toward double action
(0 to 10 psi is recommended).
01
Connect air hose to the OUT valve of the pump.
02
Open the valve cap located on the board.
03
Make sure that the push button in the center of the valve
is in the "UP" (closed) position.
04
Connect air hose to the air valve on the board and turn 90°
to secure connection.
05
Use the quick inflation mode to start inflating the board and
finish with the final inflation mode until 15 psi is reached.
06
Disconnect air hose from the air valve on the board.
07
Close valve cap.
FINAL INFLATION MODE:
Turn valve toward single action
(10 to 15 psi is recommended).
6