Publicité
Les langues disponibles
Les langues disponibles
DEFLATION
01
Open the valve cap located on the board.
02
Depress colored valve pin and turn clockwise to lock
the pin in the "DOWN'' position.
Beginning at the nose of the board, tightly roll up the SUP
03
to expel air.
Depress colored valve pin and turn counter-clockwise
04
to return to the "UP" position, then close the valve cap.
LEASH INSTALLATION
Pull leash loop through the ring
01
located at the tail of the board.
02
Pull knot through loop
and pull tight.
Open hook-and-loop fastener
03
cuff and attach leash to the
leash loop.
7
01
02
03
FIN INSTALLATION
Keep your fin in good condition by removing it after each use. Damage to the
fin incurred while attached to the paddle board may result in severe damage
to the fin box and the watertightness. Attach firmly before you go riding.
01
Unscrew the bolt and the square nut from the fin.
02
Insert the nut into the SUP's groove and push foward.
03
Insert the fin into the SUP's groove and align the bolt's hole with the nut
previously installed. Screw lightly and push backward.
04
Place the bolt and screw firmly.
01
03
05
REMOVAL
Reverse steps, 4 through 1.
02
04
Publicité
