When filing, always work from the outside of the nail towards the tip!
Always check results regularly during treatment. As soon as the application
becomes unpleasant, stop the treatment.
7. Cleaning and maintenance
Before cleaning the power unit, always unplug it from the socket out-
let!
– Clean the instrument with a slightly moistened cloth. You can also
moisten the cloth with mild soap suds to remove more stubborn dirt.
– If necessary, for reasons of hygiene, the attachments can be cleaned
with a cloth or brush moistened with alcohol. Dry them carefully after-
wards.
– Do not drop the instrument.
– Make sure that no water enters the instrument. But if this should happen,
do not use the instrument again until it is completely dry.
– Do not use chemical detergent or scouring agents for cleaning.
– Never immerse the instrument or plug-in power unit in water or other
liquids.
6 – Cylindrical milling cutter
Grinding of lignified foot nail surfaces as well as
smoothing of these. For this purpose, apply the
milling cutter horizontally to the nail surface and
remove the unwanted layer of nail using slow
circular movements.
7 – Flame milling cutter
For removing ingrowing nails. Carefully guide
the flame cutter up to the part to be treated and
remove parts of the nail as necessary.
8 – Protective cap for nail dust
This attachment ensures nail dust and skin cells
are collected.
23