Beurer MP 44 Mode D'emploi page 21

– Select the desired attachment part and carefully press it onto the axle of
the device. To remove, pull apart the attachment and the device in oppo-
sing directions.
– Switch on the device by moving the sliding switch down (anti-clockwise
rotation) or up (clockwise rotation).
– You can select the speed of the drive axle using the plus (+) and minus
(-) buttons. Start each application at a low speed and then increase as
required.
– Pink LEDs light up on the surface of the device depending on the se-
lected speed.
– All filing and callus attachments are coated with a sapphire grain. This
guarantees a long service life and ensures practically no wear.
– Do not press too hard and always carefully move the attachments to-
wards the area to be treated.
– Move the device towards the area to be treated and apply slight pressure
while slowly moving the device in circles.
– Please note that the callus attachments show reduced performance on
soaked or wet skin. For this reason, we ask that you do not soak the foot
in water before treatment.
– Do not remove all calluses to maintain natural skin protection.
– Ensure the axle can always rotate freely. The axle must not be perma-
nently blocked, as otherwise the device will become too hot and may
become damaged.
– Apply moisturiser to the treated areas after each use.
Important:
Check the results during treatment. This is particularly important
for diabetics, since their hands and feet are less sensitive.
Attachments
As these are attachments for use by professionals, we would ask you to
handle them with care as they can cause injury when used incorrectly. Parti-
cular caution is advised at higher speeds.
The following attachments are provided with your appliance:
21