Bimar KPT-2000-5159 Notice D'instructions page 13

polystyrene, metal staples, etc.) must not be left within reach of children, as they are
potentially hazardous.
 Before connecting the appliance, check that the voltage on the data plate matches
that of the electric system. In the event of incompatibility between the plug point and
the appliance's plug, have the plug replaced with a suitable model by a qualified
professional, who should ensure that the cord is suitable for the power rating of the
appliance (10A). Check that other appliances with high absorption are not connected
to the power line to avoid overloading and fire hazards. The use of adaptors or
extensions is generally not advisable; if it is necessary to use them, they must comply
with safety regulations and the total current (amps) must not be rated lower than the
maximum current of the appliance.
 Before each use, check that the appliance is in good condition and that the power
cord is not damaged: if in doubt consult a qualified professional.
 Ensure that the power cord is correctly positioned and does not come into contact
with hot parts or sharp edges, or become wound around the appliance itself and is
not twisted.
 Do not hang or even lean the appliance against any walls.
 Place the fan heater far from any other source of heat, from flammable material
(curtains, tapestries, etc.), from flammable gases or explosive objects (spray cans)
and from materials that can be deformed by heat. Make sure there is 120 cm of free
space in front of the fan heater and 50cm free space on both sides and behind it.
 The surface where the appliance is used must be stable, spacious (do not use on
shelves), level (since the appliance could tip over) and heat resistant.
USING THE APPLIANCE
First use: run the appliance to eliminate the "new smell" and any oil residue from the
manufacturing process for at least 10/15 minutes. During this operation, ventilate the
room well to eliminate the "new smell" that is given off by the appliance.
The heating fan can be adjusted using the following:
-Selector. By turning the relative knob clockwise, you can select these functions:
off, only ventilation,
-Room thermostat. It adjusts the appliance's functions according to the temperature,
continuously until reaching the set temperature, then at intervals to keep it constant.
By turning the relative knob completely anti-clockwise the heating fan remains off
(pos."-"), when turned completely clockwise it is set on the maximum temperature
(pos."+"), in intermediate positions the surrounding temperature is lower.
- Indicator light: comes on according to the thermostat's operation. It is on when the
appliance is running.
- Right-left oscillation: press the oscillation button (
swing from right to left, pos. "I", press again the button in pos "•" to off.
-Equipped with a safety device, which turns off the appliance in the event of
overheating. To start it again, remove the plug from the mains and allow it to cool
(approximately 10/20 minutes). Thereafter, plug it back in and turn it on once again.
The base has an anti-tipping switch which allows the heating fan to function only when
it is positioned correctly (when it is put in place, you will hear a "click") but it stops the
appliance if it tips.
= hot air (1000W)
13
= very hot air (2000 W).
), to allow the appliance to
0=