baltur RiNOx 60 L Mode D'emploi page 19

IGNITION AND ADJUSTMENT
Loosen the fixing screw "6" (see 0002933240) and bring the air damper into the position thought to be necessary as
a function of the quantity of fuel to be burnt. Turn the main switch to ON to power the burner and thus ignite it. Correct,
if necessary, combustion air delivery by acting on the intake damper and the position of the deflector disk (adjustable
via screw 2, see 0002933230). The burner is, in fact, fitted with a special screw to adjust the position of the deflector
disk; this device allows for optimisation of combustion by reducing or increasing the air flow between deflector disk
and head. It is normally necessary to reduce (undo screw 2) the air flow between deflector disk and head when there
is reduced fuel delivery: this passage must be proportionately more open (screw in screw 2) when the burner is
working with a higher fuel delivery rate. After modifying the position of the deflector disk it is, usually, necessary to
correct the air damper positions and afterwards check for proper ignition. The burner is equipped with an on-nozzle
light oil heater. This device provides better atomisation and thus better combustion.
AIR REGULATION PRINCIPLE DIAGRAM AND DISK-ELECTRODES SETTING
COMBUSTION ADJUSTMENT
1 AIR REGISTER OPENING ADJUSTER
- Reference index in position "0" register closed
- Reference index in position "9" register open
2 FLAME DISC POSITION
3 AIR REGISTER OPENING ADJUSTER
REFERENCE INDEX
4 AIR DAMPER IN OPEN POSITION (9)
5 AIR DAMPER IN CLOSED POSITION (0)
6 AIR DAMPER FIXING SCREW
LIGHT OIL BURNER
After having installed the nozzle, check the
correct position of the electrodes and disk
according to the following levels. It's
adviseable to check levels after every
intervention on head.
N.B. To prevent damage to the support or
the pre-heater effect nozzle assembly/
disassembly tasks with the aid of a wrench
and counter-wrench.
MOD. A
RiNOx 60L 3
N° 0002934290
Rev. --------------
-
B C D
1 4,5 2
N° 0002933240
Rev. 26/09/00
19