CASO DESIGN WineComfort 38 Mode D'emploi Original page 34

► When both - up and down zone - are working, the temperature of upper zone must be
lower than or equal to the temperature of down zone.
► In case of high temperature difference between both zones the energy consumption of the
device may be higher as indicated in the technical data.
If you press the power button of :
Down zone -> the down zone is switched on/off
When the LED lights the device is working. With pushing both
seconds, the temperature display mode will be exchange between °C and °F.
You can set the temperature as your desire: With
temperature in 1°C steps from 5-20°C.
You can switch the interior light on or off by pressing the "Light" button. The light will
switch off automatically after 4 hours to save energy. The temperature in the device depends
on the room temperature, the quantity of bottles and the chosen temperature. Please note
that your device is intended to cool wine. The maximum temperature that can be reached
inside the device cannot be significantly ABOVE the ambient temperature at the setup
location.
14.2 Rating plate
The rating plate with the connection and performance data can be founded on the back of
the device.
15 Cleaning and Maintenance
This chapter provides you with important notices with regard to cleaning and maintaining the
device. Please observe the notices to prevent damages due to cleaning the device
incorrectly and to ensure trouble-free operation.
15.1 Safety information
Attention
Please observe the following safety notices, before you commence with cleaning the device:
► Prior to commissioning, clean the appliance thoroughly.
Please note
Upper zone -> the device is switched on
and
and for 5
you can adjust the
34