Bosch EasyHedgeCut 18V-45 Notice Originale page 16

16 | English
After cutting through, the garden product continues in its
normal mode, or in case the overload condition continues
the blades automatically stop in the open position (e.g. in
Troubleshooting
Hedgecutter
Problem Possible Cause
Hedgecutter does not Battery discharged
operate
Battery not fully connected
Hedgecutter operates Internal wiring of garden tool defective
intermittently
On/Off switch defective
Motor reverses repeatedly then stops after 3 s.
Motor runs but blades Internal Error
remain stationary
Cutting blade hot Cutting blade blunt
Cutting blade has dents
Too much friction, due to lack of lubricant
Blade will not move Battery discharged
Machine defective
Excessive vibrations/ Machine defective
noise
Cutting time per bat- Too much friction, due to lack of lubricant
tery charge too low
Blade needs cleaning
Poor cutting technique
Battery not fully charged
The blades are running Battery discharged
slow or the anti block-
Battery stored outside of battery temperature
ing feature is not func-
tioning
Maintenance and Service
Maintenance, Cleaning and Storage
Before any work on the garden product itself (e. g.
u
maintenance, tool change, etc.) as well as during
transport and storage, remove the battery from the
garden product. There is danger of injury when uninten-
tionally actuating the On/Off switch.
For safe and proper working, always keep the product
u
clean.
Do not place other objects on the garden product.
To ensure safe and efficient operation, always keep the
product and the ventilation slots clean.
Never spray the product with water.
Never immerse the product in water.
Store the product in a secure, dry place, out of the reach of
children.
F 016 L94 401 | (26.10.2022)
case a piece of metal fence accidentally blocks the garden
product).
Corrective Action
Recharge battery; also see "Battery Charging"
Ensure both locking levels are engaged
Contact Service Agent
Contact Service Agent
see "Working Advice" (Anti Blocking)
Contact Service Agent
Have blade sharpened
Have blade inspected/overhauled
Apply lubricant spray
Recharge battery; also see "Battery Charging"
Contact Service Agent
Contact Service Agent
Apply lubricant spray
Clean blade
see "Working Advice" (figure E)
Recharge battery; also see "Battery Charging"
Recharge battery; also see "Battery Charging"
Allow battery to warm naturally to room temperat-
ure (within battery operating temperature 0–
35 °C)
Do not place other objects on the product.
Keep all nuts, bolts and screws tight to ensure safe working
with the product.
Inspect the product and replace worn or damaged parts for
safety.
Ensure replacement parts fitted are Bosch-approved.
Battery Maintenance
Use the following procedures to enable optimum usage of
the battery:
– Protect the battery against moisture and water.
– Store the machine and battery only within a temperature
range between –20 °C and 50 °C . As an example, do not
leave the battery in the car in summer.
– The battery must not be stored within the product but
stored separately.
– Do not leave the battery in the product in direct sunlight.
– The ideal storage condition for the battery is 5 °C.
Bosch Power Tools