Publicité
Les langues disponibles
Les langues disponibles
1. Move the choke lever (5) until it touches the top to
CHOKE position;
2. Press the carburettor primer bulb several times until it is
full of petrol. At this point the carburettor is filled with
fuel;
3. Place the throttle lever halfway between positions;
4. Pull the recoil starter (4) slowly until you feel some
resistance, then release it gently;
5. After about 30s, move the choke lever until it touches
the bottom to RUN position.
Do not set the choke lever to CHOKE position if the
engine is warm or the air temperature is high.
1.
3.
1. Move the throttle lever to the left;
2. Press the stop button.
In case of emergency, press the stop button
immediately.
1.
2.
Carburettor primer
bulb
4.
2.
The engine rotation speed is set by using the throttle lever.
With the throttle lever to the left, the engine runs at idle
speed. The speed increases as the lever is moved to the
right.
-
Idle
speed
The engine should run on a fuel mixture of unleaded petrol
and engine oil in a ratio of 1:40 (1L of two-stroke engine oil
for every 40L of petrol).
First pour the 2-stroke engine oil into an authorised fuel
mixing bottle and then add the petrol, mixing them
carefully.
Unsuitable or different fuels may lead to irreversible
damage to the engine. Low-quality petrol or oil can damage
the engine, gaskets, hoses and the fuel tank.
Keep the fuel in proper and adequate containers in a safe,
dry, cool place protected from sunlight. Fuel ages, put only
the amount needed for a few weeks.
Shake the fuel mixing bottle can before refuelling.
Pressure may form inside the tank, for this reason it
shall be opened carefully. Avoid direct skin contact
and inhalation of flammable vapours.
When filling the fuel tank (2), do not add fuel above the
maximum level of the filler neck.
+
Maximum speed
Publicité
