Publicité
1.2 FEATURES
Ignition system:
Electronic pilot ignition system with thermopile and thermocouple flame detection.
Gas control: * Optional*
Gas control valve type:
Automatic millivolt powered combination gas control valve with variable flame control for
convenience and on/off switch. Optional digital remote on/off wall switch and/or optional wall
thermostat (note: thermostats are not allowed in the United
require electricity from an external source.
Electronic Valve:
Automatic DC valve with AC power adapter. Hand held remote control.
Fan control:
Variable speed control:
For units equipped with a fan control, adjust speed by remote control settings 1-6. There are 3
fans in this unit controlled by a Hi/Low Thermodisc.
The fans cannot be shut off manually.
f i r e - p a r t s . c o m
Initial Setup
Installation of (2) AAA-size batteries will activate the setup mode. Setup mode can
also be activated by pressing the FLAME REAR and PROG/TIME buttons
simultaneously for 5 seconds. The control will exit setup mode if no button is pressed
for 20 seconds. Appropriate icon on LCD will flash when ready for setup.
Press the UP or Down button in setup mode to change the temperature scale. Press SET button to skip or
advance to Fuel Type setup.
Press the UP or DOWN button to switch control from Natural to LP, or LP to Natural Gas. Press SET button
to skip or advance to Clock setup.
Press the UP or Down Button to set the hour. Press SET to advance to minutes.
Press the UP or Down button to set minutes. Press SET to advance to AM or PM.
Press the UP or Down button to set AM or PM. Press the SET button to advance to the day of week.
Use UP or Down button to select the day of the week.
The control will exit setup mode in 20 seconds.
MODE Button
The MODE button cycles the unit through the basic operational modes.
When off, press and release the MODE button to turn the unit on in Manual mode.
Press and release the MODE button again, and the unit will operate in the Thermostat mode.
Press and release the MODE button again, and the unit will turn off.
Program Mode
The Program function is controlled by the PROG/TIME button. The control may be programmed for up to two
settings for weekdays and two settings for weekends. The control is preset to factory settings.
Supreme Remote Control
Functional Operation Matrix
States).
The gas valve does not
Page 9 of 55
Publicité
