Publicité
13
Adjust the sliding block
WARNING
Risk of injury!
Make sure that the cutting tool guard (9a) is installed on the cutter (9).
CAUTION
Product damage!
The sliding block (26) must always be correctly adjusted. An incorrect adjustment
can result in the cutter jumping out of the guide (27) or damage being caused to
the cutting tool (9).
15
– Secure the adjustment screw (31) against
turning with a suitable tool.
a a
– Loosen the nut (32) with a suitable tool.
– Change the height of the adjustment screw
(31) by turning.
– Protect the adjustment screw (31) against
turning with a suitable tool and tighten the nut
(32) again using an appropriate tool.
17
Adjusting the cutting height
WARNING
Risk of injury!
Never set the cutting height too low. The ground sliders (8) must still touch the
ground.
The cutter (9) could become caught in the ground and cause to product to
suddenly come to a halt.
– Slightly loosen the self-locking nut (33)
19
with the circlip and the washer from the
screw (34).
– Adjust the height of the ground sliders
(8).
– Re-tighten the self-locking nut (33) with
the washer and the screw (34).
a a
10 / 52
a a
b b
14
a a
16
18
a a
20
a a
a a
Publicité
