Bruder Mannesmann Werkzeuge 12598 Manuel D'instructions page 38

•
Insert the depth stop (1) and lock into place by releasing the knob (4).
•
Depending on the length of the drill bit, adjusting the depth stop will
allow you to drill a series of holes at a pre-set depth.
Fitting and changing bits
Always unplug your drill from the mains before changing the bit.
•
Your drill is equipped with an SDS-plus bushing system.
•
Clean the bit shaft from dust and coarse dirt with a dry cloth before
you insert the bit into the bushing. Add a little grease (can supplied)
to the shaft with a clean cloth or brush.
•
Pull back the locking sleeve (3) and hold it.
•
Turn the dust-free bit into the bushing as far as it will go, and release
the locking sleeve (3). The bit will lock in automatically.
•
Give the bit a tug to make sure that it is secure.
•
To release the bit, pull back the locking sleeve (3) and pull out the bit.
Chiselling
Switch off your hammer/chisel drill's turning function before you use
your drill as a chisel.
•
Press release-knob (13) and turn the turning stop
switch (6) with the arrow pointing to the marking ( )
on the machine casing.
Changing the chiselling position
You can lock the chisel in various different positions.
•
Insert the chisel into the tool holder.
•
Turn the mode selector switch (6) to the position
marked (
•
Turn the application tool to the required chisel
position.
•
Turn the mode selector switch (6) to the position ( ). With this, the
tool holder is locked.
).
GB - 38