Mopar 2008-13 Instructions D'installation page 2

2
8. Remove the four screws (1) that are securing the A/C-heater
control (2) to the instrument panel center bezel and remove
the control.
9. Remove the two screws that are securing the hazard switch to
the instrument panel center bezel and remove the switch.
10. From the back of the center bezel squeeze the two tabs at the
top and bottom of the heated seat switch and push the heated
seat switch through the opening of the center bezel.
11. Transfer the A/C-heater control (2), heated seat switch, and
the hazard switch to the new instrument panel center bezel
(3).
12. Position the A/C-heater control (2) into the instrument panel
center bezel (3).
13. Install the four screws (1) that secure the A/C-heater control
to the instrument panel center bezel. Tighten the screws to 2
N•m (17 in.lbs.).
14. Install the two screws that secure the hazard switch to the
instrument panel center bezel. Tighten the screws to 2 N•m
(17 in.lbs).
15. Install the heated seat switches. From the front of the center
bezel (2), carefully push the heated seat switch (1) in through
the front of the bezel until both tabs (3) lock into place.
04/14/2008 K6860623 Rev. 1