Tyco TA Serie Guide D'installation Et D'utilisation page 14

All manuals and user guides at all-guides.com
Menu 2:
Calibration of the temperature set value
thermometer for determining the actual floor or room
temperature. The thermometer should be put on the floor
surface, sensing the floor surface temperature, or on the
wall sensing the air temperature.
Calibration of room sensor mode <
In room sensor mode the internal sensor value is the same
as for the set value on the display.
Push the confirmation button <
Configuration mode.
Push the confirmation button <
number 2.
Change the temperature value via <
same value shown on the reference wall thermometer.
Push confirmation button several times (scroll through
Menu structure) for leaving the Configuration mode to
Normal mode
Calibration of floor sensor mode <
In floor sensor mode there is a default offset value of +4°C
between the infloor sensor value and the floorsurface value
(which is the set value on the display). The read-out value in
Menu 1 can be used for set value calibration.
Push the confirmation button <
Configuration mode.
Push again the confirmation button <
number 2.
Change the offset value via <
set temperature value will be approx. the same value shown
on the reference floor surface thermometer.
14
After stable temperature in
floor: The set temperature
value can be calibrated
against the real floor / room
temperature. This needs to
be done using a separate
>:
> in 6 sec. to enter the
> to enter menu
> buttons to the
>:
> in 6 sec. to enter the
> to enter menu
> buttons so that the