Tyco TA Serie Guide D'installation Et D'utilisation page 11

All manuals and user guides at all-guides.com
is connected, it operates in floor sensor mode. If the floor
sensor cable is not connected, it operates in room sensor
mode.
After 5 sec. the thermostat checks if an external control
signal is connected.
If yes, the thermostat will be controlling according to the
set temperature and external signal. The symbol AUTO is
activated. If no, the thermostat will be controlling according
to the set temperature.
Adjust the set temperature, desired floor temperature or
room temperature, with the < > buttons. This is an
approximate set value to get a comfort temperature on the
floor or in the room.
Heating-on symbol < > indicates on the display when the
heating cable is on.
4.2. Optional function
4.2.1 Activating Heat booster
< >
This function is used for temporary increase of the floor/
room temperature by 5°C.
Push the confirmation button < > in 3 sec. The current
set temperature will increase by 5°C for 2 hours and this
increased temperature is shown on the display. Automatic
reverts to the set temperature after 2 hours or if the
confirmation button is pushed again in 3 sec. within the
2 hour period.
If external control is connected: Push the confirmation
button < > in 3 sec. The thermostat will now be in
Manual mode. Push again the confirmation button < >
in 3 sec. The thermostat will go in "booster" mode and
the current set temperature will increase by 5°C for 2
hours. This increased temperature is shown on the display.
Automatic reverts to the set temperature after 2 hours or
if the confirmation button< > is pushed again in 3 sec.
within the 2 hour period.
11