Velleman CAMTVI9 Mode D'emploi page 5

5. Tighten the hex screws. Connect and power your camera (see below).
Check the viewing angle on your PC.
6. Slightly loosen the screw on top of the camera, adjust the sun shield
and tighten the screw.
7. Connection
1. Connect the two wires for an analogue PAL signal; leave them
unconnected for a HD 1080P TVI signal.
2. Connect the power terminal of the camera to a 12 VDC regulated
power supply.
3. Connect the video output of the camera to the video input of your DVR
using a 75 Ω coaxial cable.
Remarks:

Only use a regulated 12 VDC power adapter. Using any other type will
damage this camera.

Protect the connectors against moisture by applying some insulating
tape over the connectors.
V. 02 – 10/02/2016
CAMTVI9
5 ©Velleman nv