Publicité
Les langues disponibles
Les langues disponibles
8 electrolux
1
2
Object trap
Regularly clean out the object trap which is
located at the bottom of the drum :
1
2
5
6
OPERATING PROBLEMS
Numerous checks were carried out on your
appliance before it left the factory. Howev-
er, should you notice a malfunction, please
Problems
The appliance doesn't
start or doesn't fill:
The appliance fills but
empties straight away:
The appliance doesn't
rinse or doesn't empty:
The appliance doesn't
spin:
All manuals and user guides at all-guides.com
3
4
3
4
7
CLACK
8
CLACK
• the appliance isn't plugged in correctly, the electrical installation isn't
working, there is a power failure,
• the lid of your appliance and the drum shutters aren't closed firmly,
• the programme start command hasn't been properly selected,
• the water supply has been cut off, the water inlet tap is closed,
• the water inlet filters are dirty (see "Care and cleaning ").
• the drainage U-piece is fixed too low (see "Installation").
• the drain hose is blocked or bent,
• the drainage filter is obstructed (see "Care and cleaning "),
• the out of balance detector has been activated: washing is unevenly
distributed in the drum,
• the "Drain" programme or "Night Cycle" or "Rinse hold" option have
been selected,
• the height of the drainage U-piece is unsuitable.
• balance problem with the laundry load: add more laundry or manually
adjust the items in the drum.
Check if the filter be-
ing coupled well be-
fore closing the trap
to pull up and down
the central wall.
Water inlet filters
To clean, proceed as follows :
refer to the sections below before contact-
ing the after-sales service.
Causes
Publicité
