Télécharger Imprimer la page

FEIDER Machines FSC20V165 Manuel D'instructions page 12

Scie circulaire sans fil

Publicité

a. Charge
(ATTENTION : chargeur et batterie ne sont pas livré avec ce modèle).
1). Take the battery pack out of the equipment. Do this by pressing the side pushlock buttons.
2). Check that your mains voltage is the same as that marked on the rating plate of the battery charger. Insert the
power plug of the charger into the socket outlet. The RED LED will then begin to light.
3). Insert the battery pack into the battery charger .then the red LED on charger will begin to Green flash light.
4). You will find a label with "Charger indicator" of the LED indicator on the charger.
The battery pack can become a little warm during the charging. This is normal.
If the battery pack fails to charge, check:
Voltage at the power socket
Whether there is good contact at the charging contacts.
Whether the battery pack is warm or not, The battery protection system will not allow the battery to be charged if
the battery temperature is over 40℃ after use, allow the battery pack to cool to room temperature before
commencing with the charging.
If the battery pack still fails to charge, send the charging unit and the battery pack to our customer service center.
To ensure that the battery pack provides long service, you should take care to recharge it promptly. You must
recharge the battery pack when you notice that the power of the cordless vacuum drops. Never allow the battery pack
to become fully discharged. This will cause it to develop a defect.
Battery capacity indicator
Press the switch for the battery capacity indicator . The battery capacity indicator shows the charge status of the
battery using 4 LEDs as following:
All 4 LEDs are lit:
The battery is fully charged.
3 LED(s) are lit:
The battery has approx 75% remaining charge.
2 LED(s) are lit:
The battery has approx 50% remaining charge.
1 LED is lit:
The battery will be empty soon, please recharge the battery.
Témoin de charge
Pour afficher le niveau de charge restant dans la batterie, appuyez
Fig.2.
Indicator status
Ready for use
The charger is connected to the mains and is ready for use; there is no
battery pack in the charger.
Charging
The charger is charging the battery pack in charge mode.
Battery pack is full of charge.
Charging is finished and battery pack in the charger.
The temperature of battery is too high or too low, the charger is under
protection status. The charging function can be recovered after the
temperature is normal.
Unrecoverable battery malfunction.
sur le bouton d'indication du niveau de charge,
Explanations and actions
12

Publicité

loading