Télécharger Imprimer la page

Best WC53I Serie Instructions D'installation page 13

Publicité

Les langues disponibles

Les langues disponibles

19. OPERATION
Always turn your hood on before you begin cooking to establish an air flow in the kitchen.
Let the blower run for a few minutes to clear the air after you turn off the range. This will help keep the whole kitchen cleaner and
fresher. Operate the hood as follows:
NOTE: At range hood start-up or after a power failure, a small icon (1) appears shortly (for ± 2 seconds) on LCD screen; this is normal.
BLOWER ACTIVATION/SPEED LEVEL CHANGE/FILTER INDICATOR RESET
When blower is OFF, press on this push button to turn ON the blower at the last saved speed. If there was no speed saved, the blower will
be set on LOW speed.
NOTE: When LOW speed is activated from OFF, the blower starts on MEDIUM speed for a very short lapse of time, and then resume to
LOW speed.
To change the blower speed, press this button again until the desired speed is reached (from LOW to MEDIUM to HIGH speed to OFF).
Each time a blower speed is activated, a rotating blower icon appears on left side of LCD screen, with dot(s) under it (slow for LOW with
one dot, faster for MEDIUM with 2 dots and fastest for HIGH with 3 dots).
When blower is on (no matter the speed level), press and hold this button until the blower icon disappears from the LCD screen; this will
turn off the blower and save the blower speed chosen.
Heat Sentry™
This hood is equipped with a protective device that activates the blower when an abnormally high heat level is detected while the blower is
activated. During the Heat Sentry activation, this device takes control of the blower and set it on MEDIUM speed while all dots under the
blower icon blink. However, the lights can be still controlled. The blower will remain on MEDIUM speed until the heat is back to normal, it
then return to the speed previously selected.
NOTE: When excessive heat is detected, Heat Sentry will shut off both blower and lights while all dots under the blower icon will blink
faster. Both blower and lights will remain off until the ambient temperature cools down; the blower will then start on MEDIUM
speed (the lights can be controlled again). The blower will remain on MEDIUM speed until the heat is back to normal, it then return
to the speed previously selected.
FILTER CLEANING REMINDER
This icon appears on LCD screen 30 seconds after turning OFF the blower when it is time to clean hood and filters. This happens every
time the blower is turned OFF until the filter cleaning reminder has been reset. Once the cleaning is done, reset the filter cleaning reminder
by pressing on blower activation push button for 3 seconds while the icon appears on LCD screen for 30 seconds.
DELAY OFF
When the blower is on, press this button to activate the delay function. This icon appears on LCD screen beside the blower icon to indicate
the function is on. The blower will continue to operate for 10 minutes and then, will shut off automatically (both blower and delay icons will
disappear from LCD screen). When Delay off is activated, it is possible to change the blower speed by pressing on blower push button
without affecting the remaining time of the delay.
To cancel the delay off function before the end of the 10-minute cycle, press this button again.
ON LIGHTING/LIGHT INTENSITY CHANGE
Press this button to turn on the lights at the last saved intensity; the light icon appears on right side of LCD screen and the number of dots
below it shows which light intensity is on (one dot for LOW, two dots for MEDIUM and three dots for HIGH).
To change the light intensity, press button until the desired level is reached (from HIGH intensity, pressing again will shut off the lights).
When lights are on (no matter the light intensity), press and hold this button until the light icon disappears from the LCD screen; this will
shut off the lights and save the chosen light intensity.
MASTER ON/OFF
Press this button to turn on the ligths and the blower at the last saved intensity. When either lights or blower are ON, pressing this button
will memorize the current blower speed and lighting level prior to shut them OFF.
1
13

Publicité

loading

Ce manuel est également adapté pour:

Wc53i30bls