Publicité
Les langues disponibles
Les langues disponibles
16. REINSTALL FILTERS
Rest rear filters edge on filter springs in the range hood. Using finger cup, tilt up the
filters into position. Make sure both tabs (A) are securely engaged in range hood front
edge slots after installation.
17. LIGHTING
Do not touch lamps during or soon after operation. Burns may occur. See page 12 for appropriate replacement
LED modules.
The lighting of WC53I Series range hood is produced by two LED modules (included). The LED modules included with this hood are
the latest in LED cooktop illumination technology specially designed to operate in the elevated temperatures of cooking - offering bright
lighting and lasting up to 25 times as long as a standard bulb and greater reliability than typical replacement LED bulbs.
18. CARE
Before servicing or cleaning the unit, switch power off at service panel and lock service panel to prevent power
from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service panel.
Grease Filters
The grease filters should be cleaned frequently. Use a warm dishwashing detergent solution. Grease filters are dishwasher safe.Clean
all-metal filters in the dishwasher using a non-phosphate detergent. Discoloration of the filters may occur if using phosphate detergents,
or as a result of local water conditions - but this will not affect filter performance. This discoloration is not covered by the warranty.
Hood cleaning
Do:
• Regularly wash with clean cloth or rag soaked with warm water
and mild phosphate-free soap or liquid dish detergent.
• Always clean in the direction of original polish lines.
• Always rinse well with clear water (2 or 3 times) after cleaning.
Wipe dry completely.
• You may also use a specialized household stainless steel
cleaner
Avoid when choosing a detergent:
- Any cleaners that contain bleach will attack stainless steel.
- Any products containing: chloride, fluoride, iodide, bromide will deteriorate surfaces rapidly.
- Any combustible products used for cleaning such as acetone, alcohol, ether, benzol, etc., are highly explosive and should never be
used close to a range.
WARNING
!
WARNING
!
Don't:
• Use any steel or stainless steel wool or any other scrapers to
remove stubborn dirt.
• Use any harsh or abrasive cleansers.
• Allow dirt to accumulate.
• Let plaster dust or any other construction residues reach the
hood. During construction/renovation, cover the hood to make
sure no dust sticks to stainless steel surface.
12
HD0944
A
Publicité
