Samsung SR8855 Manuel D'utilisation page 26

Operating the cleaner
Using Guard (virtual door) mode
The VIRTUAL GUARD forms an invisible door that the
robotic vacuum cleaner cannot cross until current room is
complete cleaned. The VIRTUAL GUARD opens the invisible
door when cleaning the room is complete.
1. Select Guard (virtual door) mode using the Mode/
Power button.
- The mode lamp flashes green.
2. Set the fence length using the distance control
switch.
3. Install the VIRTUAL GUARD at the entrance of the room to be cleaned.
- Install the VIRTUAL GUARD so that the distance
detection sensor can form an invisible barrier that
the robotic vacuum cleaner cannot cross.
● When not using the VIRTUAL GUARD, turn the power off.
(When not using the robotic for long periods of time,
NOTE
separate the batteries to avoid discharging them.)
● If the Mode/Power button does not work, it indicates
that the batteries have worn out. In this case, replace the
batteries.(Specifications: Type D (LR20) alkaline batteries )
● You can additionally purchase an VIRTUAL GUARD from
Samsung Electronics customer care Co., Ltd.
About the IrdA sensor.
●
The infrared signal transmission may
CAUTION
not be smooth in locations exposed to
halogen lamps or in outdoor locations.
●
Robotic vacuum cleaner uses 3 types of
infrared devices and a device may not
work in front of another device with a
higher priority.
●
When controlling the robotic vacuum cleaner with the remote control, the robotic
vacuum cleaner may cross the virtual fence of the VIRTUAL GUARD or run against an
obstacle, because the remote control signal has a higher priority than the VIRTUAL
GUARD signal.
●
When using the robotic vacuum cleaner in a small location or at a close distance,
it may malfunction due to interference of the infrared signals.
●
Install the VIRTUAL GUARD away from the charger as auto charging may be
interrupted if the VIRTUAL GUARD is near the charger.
●
If the fence length is set to a value longer than the required distance, the robotic
vacuum cleaner may fail to clean properly.
Set the fence length to an appropriate value using the distance control switch.
●
If more than one robotic vacuum is used simultaneously, they may malfunction
due to interference of the infrared signals.
●
Turn the VIRTUAL GUARD in another direction or set the fence length to an
appropriate value if the distance detection sensor of the VIRTUAL GUARD faces
the charger, as it may interrupt auto charging.
26_ Operating the cleaner
DJ68-00518F.indb26
All manuals and user guides at all-guides.com
Room 1
Charger
Distance Detection Sensor
30c c m 30c 0c 30cm
A guard (virtual door) is formed.
✽ Since an invisible barrier is formed
to prevent the robotic vacuum
cleaner from running against the
VIRTUAL GUARD, installing the
VIRTUAL GUARD within 30 cm of
the outside walls is recommended.
[Infrared Signal Priority]
Remote Control Virtual guard
Room 2
Room 3
VIRTUAL GUARD
Charger
2010.2.231:22:27PM