Audiovox Prestige P-98 Mode D'emploi page 7

in a random shuffled order (SHF will appear on the display panel).
In Shuffle Play mode, the Forward Track Select (+) will also
select tracks in the random order instead of the normal
progression. Backward Track Select (–) will only go back to the
beginning of the track in play. The Shuffle Play mode can be
canceled by pressing the button again (SHF indication will
disappear from the display panel) or by activating the Repeat
cp cr
cr Play or Track Scan functions.
TRACK SCAN ( )
During disc play, press this button to play the first 10 seconds of
each track on the disc (SCAN will appear and the track number
on the display panel will flash during Track Scan operation). When
a desired track is reached, press the Scan button again to
cancel the function (SCAN will disappear and track number will
stop flashing) and play of the selected track will continue. Track
Scan mode will also be canceled by activating the Repeat Play
cq cm
Shuffle Play , Track Select
cs
DISC EJECT ( )
Disc play is stopped, the disc is ejected (EJ on display panel),
and the unit will change to radio operation by pressing this
button. If the disc is not removed from the unit within 10 seconds
of being ejected, it will automatically be re-loaded into the unit to
prevent damage ( IN will appear on the display panel). Press-
ing the Eject button again before removing the disc will also re-
load the disc into the unit. Discs may be loaded or ejected with
the ignition switch on or off.
ct
FRONT PANEL RELEASE BUTTON
This button is used to release the mechanism that holds the front
panel to the chassis. To detach the front panel, press the button
so that the left side of the panel is released. Grasp the released
All manuals and user guides at all-guides.com
cp
,
cn
or Cue/Review functions.
-6-
side and pull it off of the chassis. To re-attach the panel, position
the right side of the panel in place first and then press the left side
of the panel until the mechanism locks it into place.
NOTES ON USE OF FRONT PANEL
1. Make sure the front panel is right-side-up when attaching it to
the chassis as it cannot be attached when up-side down.
2. Do not press very hard on the front panel when attaching it to
the chassis. No more than light to moderate pressure should
be needed.
3. When attaching the front panel, make sure the right side is
correctly engaged before pressing the left side to lock it into
position.
4. When taking the front panel with you, please use the supplied
carrying case to protect the panel from dirt and damage. Make
sure there is no dust or dirt on the electrical terminals on the
back of the panel as this could cause intermittent operation
or other malfunctions.
cu
RE-SET BUTTON
A Re-Set button is located on the front of the chassis (front panel
must be removed to access the button). The re-set circuitry is
provided to protect the microprocessor circuitry and should only
be activated under the following circumstances as it will erase the
time and pre-set memories.
1. Upon initial installation after all wiring is complete.
2. After the position of the frequency step switch on the bottom
of the chassis has been changed.
3. If there is a malfunction of any of the switches on the unit,
pressing the Re-Set button may clear the system and return
to normal operation.