Publicité
Les langues disponibles
Les langues disponibles
9
SOUND STAGE PRE-SETS
The sound stage features allows the user to quickly adjust the
balance and fader controls for optimum listening in each of the
various seating positions in the vehicle. To select one of the five
sound stage pre-sets, enter the balance/fader mode by pressing
4
the select button
so that the
display panel. Within 5 seconds of choosing the mode, press
one of the following pre-set buttons as indicated below to optimize
listening for the five seating position:
The sound stage pre-sets are factory set to the following
conditions:
: For the left front seat
: For the entire front seat
: For the right front seat
: For the entire rear seat
: For the entire vehicle
If desired, you can change the factory sound stage settings for
each of the five seating positions by adjusting the balance and
fader levels and then pressing the appropriate pre-set button for
more than 2 seconds. The balance and fader indicator will blink
bl
when the new setting is stored.
MUTE LEVEL
To adjust the mute level, first select the mute mode by pressing
4
the select button
so that the MUTE indication appears on the
display. Within 5 seconds of choosing the mute level mode,
All manuals and user guides at all-guides.com
R
0
F
0 indication appears on the
L
R
(R2
R4)
( 0
R4)
(L2
R4)
( 0
F4)
( 0
0)
-3-
press the
button of the level control to decrease or the
increase. The mute level can be decreased to -80 (silence) and
increased to -0 (no effect) default setting is -20.
bm
LEVEL METER SENSITIVITY
To adjust the level meter sensitivity, first select the level meter
mode by pressing the select button
shown on the display. Use the
sensitivity and
button to select the Lo (Low) sensitivity setting
for the level meter display. This feature allows the user to select
the level meter scale.
bn
LOUDNESS CONTOUR (L/D)
Pressing this button for longer than 2 seconds will activate the
Loudness Contour as indicated by LOUD on the display panel.
When listening to music at low volume levels, this feature will boost
the bass and treble ranges to compensate for the characteristics of
human hearing. Pressing the button again for longer than 2
seconds will deactivate the feature and LOUD will disappear from
the display panel.
NOTE:Momentary presses of the button will change the radio
sensitivity in Seek and Scan Tuning modes from local to
distance and back again as described in section
bo
AM/FM BAND SELECTOR (BAND)
AUTO-STORE TUNING (AS)
During radio operation, each momentary press of this button will
change the radio band. The indication AMI, AMII, FMI, FMII, or
FMIII will appear on the display panel according to your selection.
Pressing and holding the button for longer than 4 seconds will
activate the Auto-Store Tuning function which will automatically
scan the AM or FM bands and enter strong stations into the
to
4
so that the LE indication is
button to select H
(High)
I
br
.
Publicité
