Targus PAWM004E Mode D'emploi page 11

All manuals and user guides at all-guides.com
Setting the Identification Code
After your computer detects the USB receiver and the
driver software is installed, you must set the ID code
between the receiver and the mouse BEFORE you can use
it. To do this:
NOTE: Make sure that your computer is turned on and
has detected the USB receiver before you set the ID
code.
1 Press and release the setup key on the receiver. The
Lock LED light turns off.
2 Press the setup key on the bottom of the mouse.
Setup Key
When the LED on the receiver is lit, the mouse is set up
with an ID and the receiver is locked.
You are now ready to use the mouse.
Power Management
• To power the mouse on and off, slide the on/off switch to
the desired position.
Targus wireless optical notebook mouse
9
Power switch