tRoUbleShotINg
Defective operation of the appliance is not always due to a technical fault but is often caused by incorrect installation or use. To avoid
unnecessary technical assistance and relative expenses we recommend the following procedures.
1. Internal temperature is not cool enough
Check • Make sure that the door closes properly;
• Make sure that the thermostat setting is correct;
• Make sure that the refrigerator is not positioned close to heat sources;
• Make sure that air can circulate freely at the rear of the appliance;
• Make sure that the condenser is not blocked.
2. Internal temperature is too low
Check: • Make sure that the thermostat setting is correct.
3. excessive appliance noise level
Check: • Make sure that the appliance is leveled correctly.
4. appliance operation failure
Check: • Make sure that the thermostat is not set to "off" or "0";
• Make sure that the power supply is not disconnected;
• Make sure that the plug is inserted correctly into the mains socket;
• Make sure that the automatic cut-out on the mains line has not tripped or that the fuse has not broken;
• Make sure that the power cable is not faulty.
Note: If the power cable need to be replaced, remove the plug from the power socket and install the new cable, which must be requested
from the Service Center and installed by a qualified technician; ensure that it is properly connected and fixed.If problems persist after
the above procedures, contact your nearest Technical Assistance department.
All manuals and user guides at all-guides.com
11
RMF-282W