installation
EN
2.2
grounding
the
appliance
WARNING
!
•
This appliance is for use with 220 volts and 240 volts.
•
A bonded/grounded power source is mandatory for this appliance.
•
This appliance must be connected to a dedicated 15 amp circuit. The use of an extension cord is NOT
permitted.
2.3
minimum
clearance
to
combustibles
2.4
minimum
mantel
clearances
WARNING
!
•
When using paint or lacquer to fi nish the mantel, the paint or lacquer must be heat resistant to prevent
discoloration.
note:
* If fi nishing materials are installed on top of the already 8" (203mm) wall, a 3/8" (10mm) clearance must be
maintained at the top of the trim in order to service the appliance.
10
W415-3030 / A / 10.29.21
Measurements
are
taken
from
the
front
trim
Bottom
Sides
Front
/
Back
Mantel
0"
0"
36" (914mm)
8" (203mm)