Whirlpool LCR5232HQ0 Guide D'utilisation Et D'entretien page 8

USING YOUR WASHER
S
TARTING YOUR WASHER
7. Select a wash/rinse temperature with the
•
Use the warmest water safe for fabric.
•
Follow garment label instructions.
HOT: 111°F (44°C) or above.
– Whites and pastels.
– Heavy and greasy soils.
WARM: 90 to 110°F (32 to 43°C).
– Bright colors.
– Moderate to light soils.
COLD: 70 to 90°F (21 to 32°C).
– Colors that bleed or fade.
– Light soils.
For portable use:
•
Set the Temperature selector to Warm/Warm or
8 8
.
( CONT
)
Temperature selector.
Match the water
temperature with the type
of fabric and soils being
washed.
Warm/Cold (depending on
your model).
•
To select a different wash
or rinse water temperature,
adjust the faucet prior to
the wash or rinse water fill.
8. Turn the Cycle Selector knob to the desired
wash cycle. See "Selecting a
cycle and time" later in this
section.
9. Push the Start/Pause button to start the
washer.
NOTE: The cycle selector
knob will NOT rotate as the
cycle progresses.
•
The Cycle Status lights
indicate the operation being
Wash
performed within the cycle.
Rinse
Final Spin
•
When the cycle is com-
Cycle Status
plete, all Cycle Status lights
will be Off.
NOTE: To change a cycle selection after the
cycle has started, turn the Cycle Control knob
to Off, then select a new cycle.
Stopping/restarting your washer
•
To pause the washer at any time, push the
Start/Pause button. The Cycle Status lights will
flash while the washer cycle is paused. If left in
pause, the cycle will terminate after 2 hours.
•
To restart the washer, close the lid (if necessary)
and push the Start/Pause button.
•
To cancel cycle, turn Cycle Selector knob to Off.
Cycle Status lights will turn off.
NOTE: When lid is opened during a cycle, all
machine operation will stop. Cycle will resume when
lid is closed.