Publicité
Les langues disponibles
Les langues disponibles
2. Hold the door open to a position that is less than 90°.
3. Replace the door stop screw or screws in the bottom hinge
and tighten.
A
A. 130°
B. 110°
C. 90°
Door-to-Door or Door-to-Refrigerator Trim
Adjustment
1. Loosen, but do not remove, the four Torx
mounting screws and the two ¼" hex head mounting screws.
2. Adjust the top hinge of either door to align it with the other
door or the refrigerator trim.
®
3. Tighten the four Torx
27 flat-head mounting screws to a
torque of approximately 100 inch-pounds (11.3 Nm) and
tighten the two ¼" hex head mounting screws.
B
®
A. Torx
27 flat-head mounting screws
B. 1/4" hex-head mounting screws
Installation Instructions
B
C
®
27 flat-head
A
Install Side Panel(s)
If the built-in area depth is 25" (63.5 cm) or more, the side panels
can be installed inside the side trim or attached to the outside of
the side trim.
IMPORTANT: Dacor is not responsible for customer installed
molding or decorative panels that need to be removed or replaced
to service the refrigerator.
1. For the inside side trim piece, slide the front edge of the
routed side panel into the trim piece.
2. Nail the rear edge of the panel to the support board.
A
A. Support board (mounted to back wall)
B. Cab side trim
Install Base Grille
There are two pieces to the base grille to allow for a custom fit:
the base grille itself and the skirt. The skirt can be added to the
base grille in order to extend it all the way to the floor.
1. To see if the skirt is needed, place the base grille into position.
Do not attach the base grille to the refrigerator. Measure the
distance between the bottom of the base grille and the floor.
The gap must be a minimum of ½" (1.3 cm) in order to add the
skirt.
NOTE: If the gap measures less than ½" (1.3 cm), skip steps 3
and 4 of the instructions, and install the base grille only.
2. Remove the film from the base grille.
B
17
Publicité
