Publicité
Les langues disponibles
Les langues disponibles
3. Slide the panel into the top grille
channel and reattach the end
cap.
4. Replace the top grille in the
cabinet side trims and pull the
panel down slightly to lock it into
place.
Door Panel Installation
1. Remove all tape and door bracing from the refrigerator and
freezer doors.
2. Open the refrigerator and freezer compartment doors.
3. Remove the handle side and top trims.
A
A. Trims
4. Slide the custom panels into the bottom and hinge side trims
on the refrigerator compartment and freezer compartment
doors, making sure that the backer panel fits into the hinge
side trims.
B
5. Reinstall the handle-side and
top trims.
6. Remove the film from the screw
covers C. Slide or snap the
screw covers into the handle
trim section.
7. Check refrigerator level and
alignment. Adjust if needed.
16
Installation Instructions
G. Panel
G
A
B. Panels
C
Adjust Doors
Door Height Adjustment
Use the following steps to adjust the door height, up or down,
after the doors have been leveled.
1. Open the freezer or refrigerator door. Locate the bottom hinge
and the door stop screws.
2. Remove the 2 door stop screws: one from the bottom side
using a
3
/
" open end wrench and one from the top side using
8
a
5
/
" hex key.
32
A. Door stop screw from bottom
B. Door stop screw from top (110°)
3. Remove the locking plate as shown.
4. Turn the bushing located underneath the bottom of the hinge
using a ½" open end wrench. Turning the bushing to the left
(counterclockwise) will raise the door. Turning the bushing
B
right (clockwise) will lower the door.
5. After adjusting, check the doors to make sure they are even at
the top and bottom. If the doors are not even, continue to turn
the bushing to adjust the door height.
6. Replace the locking plate.
7. Turn the bushing slightly to align the hinge and locking plate
screw holes.
8. Replace the door stop screw or screws and tighten. Do not
place the door stop screw in the 130° position unless the
custom panels have been routed on the hinge side.
9. Make a final recheck to make sure the doors are aligned and
even.
Door Swing Adjustment
1. Check that the refrigerator door can open freely. If the door
opens too wide, remove the door stop screw or screws
(depending on your model) from the bottom hinge. See Door
Height Adjustment earlier in this section.
A
B
Publicité
