Publicité
Les langues disponibles
Les langues disponibles
After moving the refrigerator to its final location:
1. Use a
5
⁄
" socket driver to turn the leveling bolts clockwise to
16
extend the legs to the floor as shown. The rollers should be off
the floor.
A
B
A. Rear leveling bolt
B. Front leveling bolt
2. Adjust the leveling legs to level and align the refrigerator from
left to right and front to back so that the refrigerator is level
and aligned with the cabinetry. The cabinetry surface must be
plumb for the ideal fit of the refrigerator side trim.
3. Continue adjusting all of the leveling legs to raise the
refrigerator until the top is within at least 1" (2.5 cm) of the top
soffit.
NOTE: If an anti-tip board has been used, adjust the leveling
legs until the top of the refrigerator is within ¼" (6.4 mm) of
the bottom of the anti-tip board as shown. Do not crush the
compressor cover.
2" (5.1 cm)
D
A. Center board 1/4" (6.4 mm) max. above refrigerator
B. Two 2" x 4" x 32" (5.1 cm x 10.2 cm x 81.3 cm) boards
C. Attach to studs with six #8 x 3" (7.6 cm) screws
D. Compressor cover
IMPORTANT:
- Adjust in small increments to keep from damaging the
cabinet trim and causing problems with the door alignment
or top grille fit. To avoid damage to the cabinet or leveling
legs, do not apply more than 50 inch-pounds (5.7 Nm)
of torque to the leveling bolts. The leveling legs can be
extended to a maximum of 1¼" (3.2 cm) below the rollers.
- Additional adjustments may be needed after the custom
panels are installed.
Installation Instructions
A
B
C
Custom Panel Installation
IMPORTANT:
Install the custom handles prior to installing the panels on the
ƒ
refrigerator.
Create custom door overlay panels according to the
ƒ
specifications in the Custom Panels and Handles section.
Dacor is not responsible for customer installed molding or
ƒ
decorative panels that need to be removed or replaced to
service the refrigerator.
A
B
Handle Installation
Before installing a custom panel assembly, install the custom
handle hardware.
Counter-sink the screw head into the back of the panel to allow
the panel to slide into place smoothly and for proper fit.
B
A
A. Countersunk screw
B. Handle
C. Door panel assembly
Side View
Top Grille Panel Installation
1. Grasp both ends of the top grille. Push straight up, then pull
straight out. Place the top grille panel-side down on a soft
working surface.
B
2. Remove one end cap by loosening the nuts and sliding off the
end cap.
E
C. Bottom rail
D. Nuts
E. End cap
F. Top rail
C
Front View
Front View
A
A. Top grille
B. Cabinet side trim
C
D
F
B
15
Publicité
