Napoleon GDS25N-1 Instructions D'installation Et D'opération page 24

24 24
4.8 MINIMUM CLEARANCE TO COMBUSTIBLES
4.9 MINIMUM CLEARANCE TO COMBUSTIBLES
EN EN
MINIMUM CLEARANCE TO COMBUSTIBLES MUST BE MAINTAINED OR A SERIOUS FIRE HAZARD
MINIMUM CLEARANCE TO COMBUSTIBLES MUST BE MAINTAINED OR A SERIOUS FIRE HAZARD
FRAMING OR FINISHING MATERIAL CLOSER THAN THE MINIMUMS LISTED MUST BE CONSTRUCT-
FRAMING OR FINISHING MATERIAL CLOSER THAN THE MINIMUMS LISTED MUST BE CONSTRUCTED
ED ENTIRELY OF NON-COMBUSTIBLE MATERIALS (I.E. STEEL STUDS, CEMENT BOARD, ETC.).
ENTIRELY OF NON-COMBUSTIBLE MATERIALS (I.E. STEEL STUDS, CEMENT BOARD, ETC.).
As long as clearance to combustibles is kept within the required distances, the most desirable and beneficial
As long as clearance to combustibles is kept within the required distances, the most desirable and bene cial
location for a Napoleon® appliance is in the centre of a building, thereby allowing the most efficient use of
location for a Napoleon® appliance is in the centre of a building, thereby allowing the most ef cient use of
the heat created. The location of windows, doors and the traffic flow in the room where the appliance is to be
the heat created. The location of windows, doors and the traf c  ow in the room where the appliance is to be
located should be considered. If possible, you should choose a location where the vent will pass through the
located should be considered. If possible, you should choose a location where the vent will pass through the
house without cutting a floor or roof joist.
house without cutting a  oor or roof joist.
A. A.
4" (102mm) 4" (102mm)
To ceiling from appliance top To ceiling from appliance top
Horizontal vent
Horizontal vent
Sides and bottom Sides and bottom
Top
Top
Vertical vent
Vertical vent
All sides All sides
*At a distance of 2" (51mm) from the wall, installation or service to the blower may not be practical. A minimum *At a distance of 2" (51mm) from the wall, installation or service to the blower may not be practical. A
of 5" (127mm) will be required in order to install the blower. minimum of 5" (127mm) will be required in order to install the blower.
If less than 5" (127mm) clearance is maintained between the back of the appliance and the back wall, it will be If less than 5" (127mm) clearance is maintained between the back of the appliance and the back wall, it will
necessary to disconnect the venting and gas pipe to move the appliance out for installation or service of the be necessary to disconnect the venting and gas pipe to move the appliance out for installation or service of
blower. the blower.
W415-2207 / A / 08.28.17
W415-1332 / A / 11.21.14
All manuals and user guides at all-guides.com
COULD RESULT.
NEVER OBSTRUCT THE FRONT OPENING OF THE APPLIANCE.
NEVER OBSTRUCT THE FRONT OPENING OF THE APPLIANCE.
B. B.
2" (51mm)* 2" (51mm)*
48" (1219mm) 48" (1219mm)
1" (25mm) 1" (25mm)
2" (51mm)
2" (51mm)
1" (25mm) 1" (25mm)
WARNING
WARNING
!
!
COULD RESULT.
C. C.
2" (51mm) 2" (51mm)