Beko CN 142220 DS Mode D'emploi page 23

Cleaning the water tank
Remove the water tank, open the
latches on both sides and detach the
top cover mechanism from the water
tank. Clean the water tank with warm
clean water, reinstall the top cover
mechanism and fasten the latches.
When installing the water tank, make
sure that hooks behind it fits securely
into the hangers on the door. Make
sure that parts removed during
cleaning (if any) are installed correctly
into their original locations. Otherwise,
water may leak.
Important:
Water tank and components of water
dispenser are not dishwasher-proof.
Water tray
Water that drips while using the water
dispenser accumulates in the drip tray
housing.Remove the drip tray firstly
pressing up from the front edge then
pulling towards yourself.Then clean
drip housing by a fabric or sponge that
has water absorbtion tendency.
Remove the water valve from the water
tank as shown in the diagram. When
re-fitting, make sure the O-shaped seal
is in place.
21
EN