Whirlpool 3RAWZ481G Instructions D'installation page 3

Tools and materials
needed for
installation...
Assemble the required tools and parts
before starting installation. Read and follow
the instructions provided with any tools
listed here.
• 20 cm or 30 cm (8 in. or 10 in.) pipe
wrench
• 20 cm or 30 cm (8 in. or 10 in.)
adjustable wrench (for gas connections)
• Flat-blade screwdriver
• Adjustable wrench that opens to
2.5 cm (1 in.) or hex-head socket wrench
(for adjusting dryer feet)
• Level
• 1⁄4 in. nut driver or socket wrench
• Knife
• Vent clamps
• Pipe-joint compound resistant to L.P. gas
• Sealing gun and compound
(for installing new exhaust vent)
• Pliers
Parts supplied for
installation...
Remove parts package from dryer drum.
Check that all parts were included.
NOTE: Do not use
leveling legs if
installing the dryer
on a pedestal.
4 leveling legs
All manuals and user guides at all-guides.com
Parts needed for
installation...
Check local codes and gas supplier, and
read electrical, gas and venting
requirements before purchasing parts.
93.98 cm
(37")
For close-clearance installations between
80.01 cm (31.5 in.) and 93.98 cm (37 in.),
see "Venting requirements" section.
Optional pedestal
Are you placing the dryer on a pedestal?
You may purchase a pedestal separately
for this dryer. This pedestal will add about
33 cm (13 in.) to the height of your unit for
a total height of approximately 130 cm
(51 in.).
optional
pedestal
To order, call the dealer from whom you
purchased your dryer or refer to the
"Assistance or Service" section. Ask for
Part Number XAMC893MQ (White) or
XAMC893ML (Pewter).
Stack Kit
A stack kit is provided with this unit to
allow stacking of the semi-professional
washer and dryer.
Full stacking instructions are included in
this kit.
3