Silhouette Professional DIM32D1BSSPR Manuel Du Propriétaire page 48

CONNECTING ICE MAKER TO DRAIN
Drain Type
Continuous • Excess water
Drain Mode will drain out
of the contin-
Note: This uous outlet
mode requires on the back of
the drain hose the unit using
outlet to be the force of
below the gravity.
drain-hose inlet
on the unit to
perform as re-
quired. This will
help keep wa-
ter from fl owing
back into the
unit and poten-
tially fl owing
onto the fl oor
causing water
damage.
Drain Pump • Excess water
Mode will be drained
out by the in-
Note: Pump will ternal pump.
not work during
a power out-
age. If the drain
hose becomes
twisted and
water cannot
drain, your ice
maker will not
work.
INSTALLATION INSTRUCTIONS
Drain
• The height of the drain
hole in the room
≤ 100 mm (3-15/16")
• The height of the drain
hole in the room is be-
tween 101 mm ~ 1500
mm (3-15/16" ~ 59")
Drain Height
Reference Fig. C, D and E.
1. Please ensure the drain nut and switch are
≤ 100 mm
≤ 3-15/16"
2. Connect one side of the drain pipe to the
Reference Fig. C, D and E.
1. Please ensure the drain nut and switch are
2. Using a drain pipe no longer than 16 feet
6
Operation Instructions
Drain nut and drain pump switch
Drain nut (front) (3) + drain seal (front) (4)
Drain nut (back) (7) + drain seal (back) (6) Open
Drain cap (11)
Drain cap (12)
Drain pump switch (8)
in the above condition;
continuous drain outlet and the other side
to the drain hole. The drain must slop
downwards towards the drain hole. Please
ensure the connection is tight.
Drain nut and drain pump switch
Drain nut (front) (3) + drain seal (front) (4)
Drain nut (back) (7) + drain seal (back) (6) Open
Drain cap (11)
Drain cap (12)
Drain pump switch
in the above condition;
(192"), connect one side to the drain pump
outlet and the other side to the drain hole.
WARNING
The length of drain pipe cannot exceed 16
feet (192") in order to prevent water from
coming back.
Condi-
tion
Closed
Closed
Open
OFF
Condi-
tion
Closed
Open
Closed
ON