Publicité
Les langues disponibles
Les langues disponibles
FILTER
1. Take the filtration mesh handle and pull upwards (fig.2).
2. Clean filtration mesh with mild detergent and soft brush.
3. Make sure filtration mesh is completely dry before installing.
WATER TANK
1. Pull out the water tank (fig 3).
2. Clean the water tank with a little mild detergent on a towel and
then rinse in water.
3. Put the water tank in place after drying the tank with a soft cloth.
OUTER CASING
The surface of the appliance can be cleaned using wet cloth with a
little mild detergent. Do not rinse directly with water.
STORAGE
Switch off and unplug the unit.
Clean or change the filter.
Clean and dry the water tank. Turn on the unit for a while, so the
inside can dry out completely.
It is recommended to store the unit in it's original carton.
Do not stack heavy objects on top of the unit.
TROUBLE SHOOTING
If there is something wrong during operation, it may not be the unit's problem. You may check against the
following list before send for repair:
Problem
Not working
Dedust effect/ventilation
not good.
Notice:
· If the problem cannot be found in the list or it persists, please contact our service center or a qualified
technician for further inspection.
· Do NOT open and repair the unit by yourself. Use only qualified agents for repairs or services.
EN
Possible reasons
1. The plug is not
securely inserted
into the socket or not
connected well.
2. The "ON/OFF" button
is not pressed.
1. The filtration mesh is
clogged with dust and
dirt, which affects the
unit's performance.
2. The air vent is
obstructed.
11
Solutions
1. Insert the plug pin
into the wall socket
and make sure it is
connected well.
2. Press "ON/OFF" button
after plugged.
1. Clean the filtration
mesh.
2. Remove the foreign
objects from the air vent.
fig. 2
fig. 3
Publicité
