Publicité
Les langues disponibles
Les langues disponibles
Separating the water supply line from
the refrigerator
1. Remove the water tube by pressing the coupler
( 1 ) and pulling the water tube ( 2 ) away.
CAUTION
Do not cut the water line.
Gently separate it from the coupler.
Re-attaching the Water Supply Lines
1. The Water Lines must be fully Inserted into the
center of the transparent coupler to prevent
water leakage from the dispenser.
2. Insert the 2 clips in the install pack as shown
below, and then confirm that each clip holds
the line firmly.
CAUTION
Make sure the color of the water lines match.
DA68-02981E-00.indb 12
All manuals and user guides at all-guides.com
(1)
(2)
Center of Transparent coupler
Clip A (1/4")
(6.35 mm)
English - 12
Removing the freezer door
A few things to mention first.
• Make sure that you lift the door straight up so
the hinges are not bent or broken.
• Be careful not to pinch the water tubing and
wire harness on the door.
• Place doors on a protected surface to prevent
scratching or damage.
• Is necesary two people for disassembling
doors.
1. With the Freezer door closed, remove the
upper hinge cover ( 1 ) using a screwdriver, and
then disconnect the wires ( 2 ).
(1)
Be careful, no damage sensor harness
with cover hinge.
2. Remove hinge bolts ( 3 ) and a ground screw
( 4 ) counter-clockwise, and take off the upper
hinge ( 5 ) in the direction of the arrow.
Be careful when removing the door to ensure
that it does not fall on you.
(4)
(3)
(5)
3. Before remove the bolts, disassembling Cover
Leg front and hoses.
Remove the door from the lower hinge ( 6 ) by
carefully lifting the door ( 7 ).
(7)
(6)
(2)
Pressing
13. 12. 12.
3:07
Publicité
