Télécharger Imprimer la page

RIDGID WD0600 Mode D'emploi page 10

Publicité

Les langues disponibles

Les langues disponibles

Maintenance
Filter
WARNING: To reduce the risk of
injury from accidental starting,
unplug power cord before changing
or cleaning filter.
NOTE: This filter is made of high quality
paper designed to stop very small parti-
cles of dust. The filter can be used for wet
or dry pick up. Handle the filter carefully
when removing to clean or installing it.
Creases in the filter pleats may occur from
installation but creases will not affect the
performance of the filter.
Cleaning
Your filter should be cleaned often to
maintain peak vac performance.
Be sure to dry the filter before storing or
picking up dry debris.
IMPORTANT: After cleaning, check the
filter for tears or small holes. Do not use a
filter with holes or tears in it. Even a small
hole can cause a lot of dust to come out of
your vac. Replace it immediately.
Removal
To remove the filter for cleaning or
replacement, unscrew the filter nut from
the filter cage and lift off filter.
WARNING: Do not remove the filter
cage. It is there to help prevent your
fingers from getting into the blower
wheel.
Wet/Dry Vac
To keep your Wet/Dry Vac looking its best,
clean the outside with a cloth dampened
with warm water and mild soap.
To clean the drum:
1. Dump debris out.
2. Wash drum thoroughly.
3. Wipe out with dry cloth.
All manuals and user guides at all-guides.com
IMPORTANT: To avoid damage to the
blower wheel and motor, always reinstall
the filter before using the vac for dry mate-
rial pickup.
Dry Filter
1. Some removal of dry debris can be
2. For best cleaning results due to accu-
3. After filter removal from vac, remove the
4. For thorough cleaning of dry filter with
Wet Filter
After filter is removed, run water through
the filter from a hose or spigot. Take care
that water pressure from the hose is not
strong enough to damage filter.
Installation
Refer to page 5, "Filter Assembly".
Allow the filter to dry before reinstalling
and storing the vac.
WARNING: To assure product
SAFETY and RELIABILITY, repairs
and adjustment should be per-
formed by Authorized Service Cen-
ters, always using RIDGID
replacement parts.
NOTE: If your casters are noisy, you may
put a drop of oil on the roller shaft to make
them quieter.
10
accomplished without removing the fil-
ter from the vac. Slap your hand on top
of the lid while the vac is turned off.
mulated dust, clean the filter in an open
area. Cleaning SHOULD be done out-
doors and not in the living quarters.
dry debris by gently tapping the filter
against the inside wall of your dust
drum. The debris will loosen and fall.
fine dust (no debris), run water through
it as described under "Wet Filter".

Publicité

loading

Ce manuel est également adapté pour:

Wd0800